After defining this setting, connect the server node and storage device to the Fibre Channel switch, and set up an access path using this software. To prevent inadvertent access from destroying data on the storage side, recommend to set the temporary zone as follows.īy this setting, it is able to stop all access paths of the Fibre Channel switches. When Fibre Channel switches that are not set the zoning are connected to server nodes or storage devices, they are placed in a state where their security levels are undefined (which makes all of the Fibre Channel switches accessible from every server node). No zoning may be set for Fibre Channel switches.
Refer to the manuals provided with the respective devices for details on the setting method. SysName should be a name that is not identical to any other name registered with this software.
This software uses this host name as SysName. Register a host name for Fibre Channel switch control. In order for the setting to match the changed device setting, perform a change to the account information for device management using the Web Console. If the password has been changed on the device side, when perform for the relevant device with the Web Console, this software recognizes the change and the device status becomes a Warning display. The factory default settings of user name and password are "admin" and "password", respectively. Control requires a user name and password of the administrator security level. User Name and Password for Fibre Channel Switch Controlįor Fibre Channel switch control, this software is used to log in using SSH to the device. Make the required settings for the Brocade VDX series which you use to connect to a network, and then connect to the network.